15
Control Panel
The Control Panel is easy to use with fingertip control of all the spa functions.
Temperature Control
To increase the temperature, turn the Temperature
Control Knob clockwise to the desired setting. To
reduce the temperature, turn the knob counter clock-
wise.
Function Control Button
Press the Function Control Button once and the low
speed pump will operate. Press the button again and
both the low speed pump and spa light will operate.
Press the button a third time and the high speed pump
and spa light will operate. Press the button a fourth time
and the high speed pump will operate without the light.
(The high speed pump will turn off automatically after 15
minutes of operation.) Push the button again and the
system will turn off.
Filter Cycles
Your spa will automatically filter itself for 2 hours
twice a day. During filtration, the low speed pump will
activate. The first filter cycle will begin one minute after
the spa has been energized. The second cycle will begin
twelve hours after the start of the first cycle.
STATUS/
HEAT
WARM
STATUS/HEAT
INDICATOR
COOL
FUNCTION
CONTROL
BUTTON
OFF
LOW
LOW / LT
HIGH
•••
••••
•••••
•
••
HIGH / LT
TEMPERATURE
CONTROL
KNOB
Over Heat Protection
In the event the spa should overheat, the Status/
Heat LED will flash and the spa will shut down. If this
situation occurs, turn off all power to the spa and contact
your dealer or service organization. To reset the spa,
press the Function Control Button.
Flow Switch Detection
If the pressure switch malfunctions, the Status/Heat
LED will flash. If this situation occurs, turn off all power
to the spa and contact your dealer or service organiza-
tion.
Open Sensor
If either the high limit or water temperature sensors
malfunction, the Status/Heat LED will flash. If this
situation occurs, turn off all power to the spa and contact
your dealer or service organization.
The spa will automatically begin to operate when electrical power is applied. There is no ON/OFF switch for the
spa system.
The control system has been designed so that by connecting the spa to its properly grounded power source, it
will begin to operate. The Status/Heat LED will light briefly. The pump will activate if the temperature of the water
is less than 65
°
F.
Alexa Control Panel
OPERATION
