15
CHAPTER 1 - PRECAUTIONS
J-600 ELECTRIC
Recommendation to unload the equipment
> Warning To Hook up the Equipment to the Tracto’s Traction Bar
∙ Desengage the equioment from the tractor, hook
the jack. Do not forget to install the safety chain in
the traction bar.
∙ The unload must be in specific’s places for this
type of job. Do not make improvisation to unload
the equipment.
∙ During the strap’s remove that holds the equio-
ment, make sure to use EPI. If the equipment is
used use EPI to unload the equipment (i.e..: safety
boots, gloves, helmet, etc.) with the EPIs used for
spraying (i.e.: mask, gloves, etc.), to minimize the
contamination risk and accident.
∙ To unload the equipment, use a tractor with ca-
pacity for this type of job. The tractor to be used
must be according to it pull capacity and sprayer
weight.
∙ Do not desassemble removable parts from the
equipment such: PTO shaft, etc; before unloading
the equipment from the truck or trailer and park in
a safety area.
∙ After positioning the equipment in a safety area
and far from electric post, hook up the jack and
unhook the equipment from the tractor.
∙ Check the owner’s manual prior to do this
operation. The warning realated to follow are re-
commended just for the J-600 ELECTRIC hook
up too the tractors. Warning related to the use
and component’s adjustment of the tractor are it’s
manufacture’s responsabilities.
∙ The information related to the correct adjustment
of the trantion bar and the procedures to hook up
the equipment the right way are exposed in chap-
ter “ASSEMBLY” in this manual.
∙ The hook up operation of the equipment to the
traction bar can be made for more than one per-
son. In this case, the people involved must be awa-
re of risks, trained, qualified and experiencied this
type of job.
∙ Avoid to stand on the tractor’s way. If possible,
hook up the equipment by yourself. Do not forget
the safety chain in the traction bar.
∙ Before to get out of the tractor to do the hook uo,
activate the parking brake Turn off the engine and
remove the key from the ignition.
∙ After hooking it up, put on the jack on the working
position and move the equipment to the place
where the assembly will be made.
