5
CHAPTER 5 - MAINTENANCE
J-600 ELECTRIC
Belt tension
∙
Check the belts tension periodically.
∙
Press the agitator belts as shown in the figure
beside. When pressed it should slack 0,39 to
0,59 in. DO NOT USE SHARP-ENDED OR CUT-
TING TOOL.
> PTO Shaft
ATTENTION!
Always stop the machine and turn off
the the tractor before any and all kind
of maintenance and use appropriate
protective clothing, such as: gloves,
boots, goggles, etc.
> Belt tension
∙
Lubricate daily.
For instruction in detail, please refer to the section
MAINTENANCE - PTO SHAFT.
2
1
> Pump belt
∙
Deflection: +/- 0.20 in
∙
Loosen the two screws (1).
∙
Slide the pump (2) until obtaining the tension
recommended.
∙
Retighten the screws (1).
ATTENTION!
Before using the equipment for the
first time, clean and lubricate every
point of the PTO shaft, as shown in
the picture above, with Lithium-
based grease NGLI-2 (for further in-
formation about the greases, refer to
the lubrication table).
