3 ADJUSTMENTS
GB-12
3.12 REEL CONTROL __________________________________________________________
Adjust the reel control lever linkage so the reels
disengage when they reach the raised position.
1. Remove front cowling and raise mowers. Shift all
reel control levers to “OFF” and stop engine.
2. Adjust link
(R)
so there is 1/32 to 1/16 in. (0.8 to
1.6 mm) clearance between the bottom of the
shoulder bolt
(S)
and the bottom of the slot in link
(R)
.
3. Remove all hardware holding link
(R)
in place then
loosen nut
(T)
and adjust the link.
4. Tighten nut
(T)
against the link. Reassemble all
components and tighten hardware.
Figure 3J
3.13 REEL SWITCHES__________________________________________________________
The reel lever linkage actuates two electrical switches
located under the levers. Check that both switches are
closed when all reel levers are in their NEUTRAL
position.
1. Check and make sure switches are wired correctly.
Refer to
Figure 3K
and labels attached to wires for
correct terminal placement
2. When any of the reel levers are moved to the
forward position, Reel Switch (Wires A and B)
should open, and Backlap Switch (Wires C and D)
ahould remain closed.
3. When any of the reel levers are moved to the
reverse position, Backlap Switch (Wires C and D)
should open and and Reel Switch (Wires A and B)
should remain closed.
Figure 3K
3.14 STEERING WHEEL (GK IV UNITS ONLY) ______________________________________
1. Loosen cable mounting nut (BB) or (CC) as neces-
sary and tighten opposite nut until steering wheel is
square with the frame and tractor runs straight
ahead.
2. After steering wheel is adjusted, adjust both cable
mounting nuts until there is 1/2 to 5/8” (13 to 16
mm) deflection in center of cables with a 10 pound
(4.5 Kg) pull.
Figure 3L
1/32 to 1/16”
(0.8 to 1.6 mm)
T
R
S
A
B
C
D
Reel Switch
Backlap Switch
BB
CC
1/2” to 5/8”
(13-16 mm)
Summary of Contents for Greens King IV Plus
Page 28: ...7 NOTES GB 28 7 NOTES...
Page 29: ...NOTES 7 GB 29...
Page 56: ...7 NOTAS PT 28 7 NOTAS...