ADJUSTMENTS 3
GB-11
3.8
PARKING BRAKE__________________________________________________________
Disengage brake lever and measure the distance
between nut
(G)
and bottom of pivot. Adjust nut so the
distance is 3/16” (5 mm).
Figure 3H
3.9
INTERLOCK SWITCHES ____________________________________________________
1. Refer to the Interlock System check in your Safety &
Operation manual. If the system
fails
any test listed,
adjustment or replacement of the switches or levers
is required
2. Remove the front cowling and check the control
linkages to be sure they are properly adjusted
(Sections 3.8, 3.10 and 3.12).
3. Check switches to make sure they are working
properly.
3.10 TRACTION LEVER _________________________________________________________
1. Remove front cowling and adjust lever to align with
the four positions on the instrument panel.
2. Adjust ball joints
(M)
on rod
(N)
and/or adjust
position and number of washers
(P)
for proper
alignment. The lever must engage neutral start
switch in “NEUTRAL” position only.
Figure 3I
3.11 CHOKE CONTROL _________________________________________________________
Gas Engines Only
1. Push choke control knob to the “Off” Position.
2. Set Choke lever at carburetor to “Off” (butterfly
open) position.
3. Adjust control wire (at the carburetor) then clamp
wire housing in place while keeping choke butterfly
open and the control knob in the “Off” position.
3/16”
GKV-13
G
(5 mm)
CAUTION
Never operate equipment with damaged switches.
Replace faulty switches immediately.
!
P
M
N
M
GKV-15
Summary of Contents for Greens King IV Plus
Page 28: ...7 NOTES GB 28 7 NOTES...
Page 29: ...NOTES 7 GB 29...
Page 56: ...7 NOTAS PT 28 7 NOTAS...
