en-41
CONTROLS 6
6.5.8 WEIGHT TRANSFER _________________________________________________
Weight transfer function transfers ground pressure between the cutting
units and the road wheels, giving either optimal ground following of units
or increased traction at the wheels. Weight Transfer can be selected from
the
Settings
menu (Section.6.5.4), and then
Enabled
or
Disabled
within
the
Weight transfer
menu. Use
Button 2 and 3
to navigate the two op
-
tions and then
Button 4
to select.
Once enabled the weight transfer will be active unless a lift or lower com
-
mands is given (Section.6.7). Weight Transfer will automatically be disa
-
bled to allow the units to lift and lower. There will be a few seconds delay
before Weight Transfer automatically re-engages after the lift or lower
command is given which varies depending on which unit is raised or low
-
ered.
The weight Transfer icon displays on home screen and shows whether it
is currently active or not. The weight transfer pressure can be adjusted as
instructed in Section 9.2.
6.5.9 RESET DEFAULT PARAMETERS _______________________________________
The machine will have factory set
defaults. You can reset to factory
settings by Using the PIN Menu
Buttons 2 and 3
to
arrow up and
down
,
and
Button 4
to
select Set
Default Parameters. Press arrow to
confirm.
6.5.10 CHANGE PIN _______________________________________________________
Using the PIN Menu
Buttons 2 and 3
to
arrow down to the bottom of the
list
,
and
Button 4
to
select Change Pin, this gives you the option to
change from the default Owner’s PIN Number.
Weight Transfer
Disabled
Enabled
Disengaged / Not Active Engaged & Active
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
Set Default Parameters
Press To Confirm Set
To Default Parameter Values
Are You Sure?
Yes
No
Change Pin - Owner
New PIN: * * * *
Confirm: 1 _ _ _
