Jackson RackStar 44, Installation, Operation And Service Manual, Page: 32 / 80

25
07610-004-33-05-B
OPERATION
DELIME INSTRUCTIONS
To proceed with the delime operation, fill the dishmachine with the correct amount of delime
solution as recommended by the chemical supplier. The tank capacities of the machine can
be found in the Specifications section of this manual.
After the chemicals are added, perform the following steps:
1.
Press the
DELIME button.
2. Disconnect or turn off chemical feeder pumps.
3. Close the doors.
4. Pre
ss the START button and run the machine for the length of time
recommended by the chemical supplier.
5.
Press the START button
to shut the unit off.
6.
Wait five minutes, then inspect the inside of the machine. If the machine is not
delimed, run again.
7.
Once clean, drain and re-fill the machine and run two cycles to remove residual
deliming solution.
8.
Drain and re-fill the machine.
9. The machine is ready to use.
This equipment is not recommended for use with deionized water or other
aggressive fluids. Use of deionized water or other aggressive fluids will result in
corrosion and failure of materials and components. Use of deionized water or other
aggressive fluids will void the manufacturer’s warranty.
DELIME
INSTRUCTIONS