第 4页共 10 页
2.3
Operation panel auxiliary functions
2.3.1 User parameter adjustment
Normal boot, press
key to enter user parameter mode. Press the Left/Right key to move the cursor and the corresponding value digit flashes,
then press the Plus/Minus key to modify the value of the digit. Press
key, the parameter number flashes, and save the parameter.
Press
again to exit.
2.3.2 Needle stop position setting
In the power-on state, press
+
key to enter the monitor mode (display 024 parameter interface). At this time, turn the hand wheel to the
upper needle position as required. The displayed value will change with the hand wheel position. Press
+
key to “set zero” to
parameter value measured after 024 in the interface, confirm the upper needle position is OK, and calculate the lower needle position
automatically at the same time.
2.3.3 Parameter save setting
In the monitoring interface state (press
+
key to enter), long press
to save the current parameters. In the power-on state, long
press
key to restore the saved parameters.
2.3.4 Version number query
In the power-on state, press
+
key to enter the version display interface, and switch the display of program versions by pressing the
Plus/Minus key, h**-**-** represents the panel program version; A**-**- ** represents the master control program version; V5-**** represents the
voice version; V2-**** represents the recovery code.
Presser foot
key
1, Short press
key, the icon
of LCD is lit, the c sewing after the end of automatic trimming
presser foot function turns on.
2,Long press
Key, the icon
of LCD is lit, the cycle sewing midway parking presser foot
function turns on.
Thickness
monitoring key
If clicked, set to use or cancel the thickness monitoring function.
If long press, it will enter the thin-thickness detection parameter mode.
Presser foot
key
1, Short press
key, the icon
of LCD is lit, the c sewing after the end of automatic
trimming presser foot function turns on.
2,Long press
Key, the icon
of LCD is lit, the cycle sewing midway parking presser
foot function turns on.
Parameter
increment key
1. In the Home interface, press
key to increase the speed by 50 rpm each time.
2. In the Parameter Setting, parameter value increment key.
Parameter
decrement key
1. In the Home interface, press
key to decrease the speed by 50rpm each time.
2. In the Parameter Setting, parameter value increment key.
The left
selection key
Parameters selection toward to left key. ( In constant-stitch sewing mode, long press this key,
One-shot-sewing can be turned on or turned off. )
The right
selection key
Prameters selection toward to right key.
Parameter
setting key
In the boot state, long press
key to enter the parameter modes. After modify the parameters,
press
key to storage. Then long press
key to exit this mode.
Factory reset
Long press button for 5 seconds to restore the factory Settings.
