www.jaboboat.com Email: [email protected]
Phone:189 2833 0369
10
Left Handle
Right Handle
Combination: F+Right Handle
Operation Guide.
1. Installation of the lithium battery in the boat: The lithium battery of the nesting boat
has been installed in the boat when it leaves the factory, when the user receives
the boat you only need to open the hatch cover (don’t pull out the plugs that have
been inserted), and connect the battery plug to the power socket inside the boat. When
connecting, pay special attention to the polarity of the battery not to be reversed or
reversed. Otherwise it will burn out the receiver and motor drive board. The correct
connection method is to insert the red wire of the plug to the red wire of the socket,
and the black wire to the black wire. After the plug is connected, cover the cabin. The
remote control battery is rechargeable with a USB connector so no need batteries.
2. Function test: Before launching the nest boat, perform a function test.
Power on: Put the nesting boat in a stable place, then turn on the power switch on
the hatch cover, the two tail lights start to flash, indicating that the receiver is working
normally.
Turn on the power switch of the remote control, the tail light changes from flashing
to off, the remote control and the receiver are successfully coded. In order to use
multiple boats at the same water at the same time, an address code (serial number) is
set in the remote control circuit. The serial number of the remote control at the factory
defaults to "000". Each time the nesting boat is turned on, the receiver will first
receive the address code (serial number) of the remote control. Once the code is
completed, as long as the boat’s power switch is not turned off, the boat will receive
the control command of the remote control that is coded with it. In this way, multiple
boats can be operated on the same locations without affecting each other. It should be
noted that every time the nest boat turns on the power switch, there will be a code
matching process.
Forward: Push the handle of the remote control forward, and the two motors of the
nest boat start to rotate. The left and right direction lights are always on. At this time,
the nesting boat is in a forward state.
Turn left; turn right: Push the handle of the remote control to the left or right, and
the nest boat will make a left turn (the right motor rotates forward, the left motor
reverses, and the left direction light flashes), then turns right (left The side motor