www.jaboboat.com Email: [email protected]
Phone:189 2833 0369
6
longitude coordinates display a series of "X". At this time, the "X" is meaningless.
After the boat has established a connection with the satellite, the displayed value of
the latitude and longitude is the current satellite positioning of the boat.
After setting the start position, enter the operation page, start operating.
Parameter setting:
After entering the operation page, press the key "S", the screen enters the parameter
setting page:
Sensitivity
50
Sonar sensitivity could be between 01-99,the highest sensitivity does
not mean it is best,when in highest value,it will vastly increase the
interfering signal,the data shown may not be referred and thus useless,
the default value i 50,which suits water depths from 1.8-10
meters(6-33ft deep)
Serial number
001
The serial number is the code of the remote control. Remote controls
with different codes are used in the same water without interfering with
each other. 0-250 serial numbers can be set. Factory default "000"
Temperature
º
F
The temperature unit shows Celsius and Fahrenheit.
Length Unit
FT
Length unit is feet
Beep
On
Key tone, which can be turned on or off
Backlit
On
LCD backlight, selectable on or off
Depth range
Auto
Depth range "m": The default setting is "Auto".
Speed Rate
80%
Speed adjustment, default is 80%, range is 60-99%
Refresh
5
Refresh adjustment is to adjust the LCD screen shift time, the
adjustment range is 0-9 seconds,default is 5 seconds.
Compass Ca
00
This compass calibration is different from the compass calibration at
startup. It is used to fine-tune the angle of the compass when the
electronic compass is deviated. The adjustment range is -30
—
+30
°
.
The adjustment method will be explained in detail later.
Off track
00
It is used to adjust the yaw of the boat. When the boat is leaning to one
side when going straight, it can be adjusted through this item.
Adjustment range -50-+50.
Function buttons on the right: