With the master code the supervisor can arm and disarm both sections. If the
master code is entered, the system will arm (if completely disarmed) or disarm (if
any section is armed).
Entering
F1 master code
will control only section
A
and
F2 master code
only
section
B
(this is true only when fast arming is disabled by the installer).
Note: partial Home arming is not possible if the system is split.
2.10 Subsystem
arming
In a large building a sub control panel can be enrolled to the JA-63. The
subsystem reports all alarms and failures to the main system.
The installer can program if the systems will be armed and disarmed separately
(by their own codes and remote controls) or if the main control panel will rule the
sub control panel. Ask your installer for explanation on how to operate your
system if a sub control is panel installed.
2.11 Appliance
control
The system can be used to control an electrical appliance (light, heating,
ventilation etc.). In such a case users can operate the device:
Locally with keypad*
– entering
F81
(ON) or
F80
(OFF). The JA-60D
keypad does not support this feature.
Remotely by phone keypad or by SMS messages
– the control panel
must be equipped with GSM communicator for this feature
*
Installer can program that this feature will work only when the entry is followed by a user code.
3 User’s settings
Following section is designated for the system supervisor, who knows the
master code.
All programming sequences can be terminated before completed (by
N
key).
3.1 New master code
The master code is used by the supervisor. The
factory default
master code is
1234
and you should program your own four digits code. Code programming is only
possible when the system is disarmed.
To change an existing master code enter:
F 5 xxxx yyyy yyyy
where
xxxx
is the existing and
yyyy
is the new master code (new code must be
entered twice to avoid an error).
Example:
Existing code 1234 will change to 6723 entering: F 5 1234 6723 6723
Alarm system JA-63 „PROFI“
- 8 -
MGK51501
