J-109– Page 25/37
11.3.
OPERATION OF THE MARINE WC
-
Open the seawater inlet valve.
-
Open the seawater drain valve.
-
Set the lever to the ''OPEN - FLUSH' position'.
-
Operate the pump.
-
To empty the bowl and avoid the water moving around when listing, set the lever to
''CLOSED - DRY BOWL''.
-
Run the pump until the bowl is dry.
-
When the WCs are not being used, set the lever to the ''CLOSED - DRY BOWL''
position
-
Close the valves after use.
Never throw anything into the WCs. If the drain should become blocked, check that the
valves are correctly closed before disconnecting the pipes.
12.
FLOODING / DRAINING
12.1.
. CHARACTERISTICS OF THE DRAINAGE SYSTEM
The
J
109 has two bilge pumps enabling the vessel to be pumped out:
-
A 12V DC bilge pump with a minimum flow of 30 l/min located in the keel sump. This
pump is fitted with a level contactor; you can choose between automatic and forced
operation.
-
A manual bilge pump, located in the cockpit, pumping out in front of the engine
compartment or in the keel sump.
Carefully read the instructions for the pumps, especially regarding their maintenance.
12.2.
DRAINAGE CIRCUIT (See Drawing)
Ensure that the bilge pumps are in good operating condition before putting to sea.
Familiarize yourself with the bilge pump system
-
Locate the hand pumps and their operating lever,
-
Locate the switch for the electric bilge pumps on the electrical control panel.
Summary of Contents for J/109
