24
EN
PG-300
• Rinsing attachments under water (above)
requires lubricating the cutting blades 1×
monthly. Using only light-grade oils (e.g.
sewing machine oil), simply spread 1-2
drops lightly over cutters with fingertip. Wipe
away all excess.
• Use only light-grade oils as these will not
evaporate nor slow down speed of cutting
blades.
• Do not use hair oil, grease, or any oil mixed
with kerosene nor solvent as these too will
evaporate.
• Do not use the appliance while bathing or
showering.
Cleaning the Foil Shaver
IMpoRTANT
: Neither rinse nor oil
foil shaver attachment as this is
permanently lubricated.
• Remove the head and shake it to remove
excess clippings.
• Replace the attachment by gently snapping
it into place.
• The shaving foil is very delicate and should
not be handled. Do not apply pressure to
shaving foil.
• Do not clean the foil with the brush, as this
may cause damage.
• If the foil shaver is worn out or has visible
signs of damage, do not use it and contact
and authorized Benrubi Service Center to
replace it.
Storage
• Make sure that the groomer is turned off.
Remove the power cord from the outlet and
the charger from the groomer before storing
it in a safe, dry location where it will not
be crushed, banged, or subjected to any
damage.
• Store the groomer and its attachments in the
storage stand to prevent damage.
• Do not wrap the power cord around the
groomer or the stand when storing.
• Store the charger and its power cord in
a safe location where it will not be cut or
damaged.
• Do not store the groomer in places with
temperature exceeding 60
°C.
Replacing of Accessories
• If the attachments of the groomer become
damaged or worn, do not continue using
the groomer. The attachments should be
replaced immediately by an authorized
Benrubi Service Center.
Battery Removal
NoTE
: Always recycle or properly dispose
of batteries according to Local and State
requirements.
• Unplug the groomer from the outlet to avoid
risk of electrical shock.
• Remove the rear groomer cover by first
prying the rubber panel from the product
with a flat head screwdriver.
• Next, pry the back panel from the product
with a flat head screwdriver. This will expose
the batteries.
• With wire cutters, clip the wires leading to
the batteries.
• Remove the batteries from the product
.Contact your local authorities for proper
disposal.
CAUTIoN
: THESE BATTERIES MUST
BE RECYCLED OR DISPOSED OF
IN ACCORDANCE WITH STATE AND
LOCAL REGULATIONS.