19
EN
PG-300
Spare parts
• Full size trimmer
• Precision trimmer
• Nose and ear trimmer
• Shaver attachment
• 2 guide combs
• Charging adaptor
The spare parts are available at the
authorized Benrubi Service Centers.
Charge / Recharge
• Fully charge the groomer before using for
the first time or after non-use for a long
period of time.
• Battery performance is best if you recharge
only when the battery is (almost) completely
empty.
• Charging or recharging at temperatures
below 40°F or higher than 95°F adversely
affects the lifespan of the battery.
IMpoRTANT
: Continuously recharging
of the groomer will reduce the lifespan
of battery.
• Be certain that the groomer is switched off
before charging.
• You may charge the groomer by inserting
the chargers end directly into the shaver.
• Inset the charging plug into any AC220-
240V~ 50Hz outlet. Use only the cord
provided.
• After a few moments, the red charging light
on the power plug will light to indicate that
the groomer is charging.
• It will take approximately 14-16 hours
to fully charge the groomer for optimum
performance.
• After charge, disconnect the cord and
unplug the charger from the electrical outlet.
optimize the working life
of the battery
• After the groomer has been charged for
the first time, do not recharge the groomer
between trimming sessions. Continue using
it until the battery is completely empty.
• Do not charge for more than 24 hours.
• Do not keep the charger permanently
plugged in.
• Discharge the battery completely twice a
year by letting the motor run until it stops.
• If the groomer has not been used for a long
period of time, it must be recharged for 14-
16 hours.
Cordless Trimming
• Charge the appliance according to
directions. Unplug the appliance from the
outlet.
• Slide the ON/OFF switch upwards to begin
trimming.
• If the battery is empty and you want to trim
your beard, charge the groomer for at least
3 hours and you will have enough power for
one use (10 minutes).