9
To deactivate the boiler resistor press the key
for about 2 seconds and
the display shows
OFF
.
To activate coffee boiler resistor, simply press the key
.
Press the key
to program the temperature setpoint, when the display
shows
Prg
press the key
.
Once the temperature setpoint has been displayed, use the keys
and
to set the desired value, from a minimum of
121°C
to a maximum of
128°C.
3 seconds
after pressing the last key the data is memorised and the
display shows the temperature.
With the machine of, press the keys
and
at the same time and
keeping them pressed turns the machine on. When the display shows F.03,
release the keys.
The key
scrolls the parameters while the key
confirms the selected
parameter. To quit programming, turn the machine off and then on again.
N.B. It is recommend to use the default parameters set by the
manufacturer (see Par. 5.4).
5.3 PRESET PARAMETERS
To perform the PRESET, with the machine off press the key
and turn on the
machine.
When the display shows PrS, release the key and turn the machine off and
then on again. Reset all values as per the "Default Parameters" table (Par.
5.4), for the desired temperature refer to the "temperature range" table.
It is possible to reconfigure the Display with default parameters (factory
settings) using the PRESET operation.
To perform the PRESET, with the machine off press the key
and turn on the
machine. When the display shows PrS, release the key and turn the machine
off and then on again.
