IXIA XGS2-HS, Getting Started Manual, Page: 76 / 90

with a Flat Blade or Phillips Screwdriver
NOTE: The installation of your equipment and rack kit in a rack cabinet has not been approved by
any safety agencies. It is your responsibility to ensure that the final combination of equipment and
rack complies with all applicable safety standards and local electric code requirements. Ixia disclaims
all liability and warranties in connection with such combinations. Rack kits are intended to be installed
in a rack by trained service technicians.
When setting up the equipment for use:
l
Place the equipment on a hard, level surface.
l
Leave plenty of clearance on all vented sides of the equipment to permit the airflow required for proper ventilation. Restricting airflow can
damage the equipment.
l
Ensure that nothing rests on your equipment’s cables and that the cables are not located where they can be stepped on or tripped over
l
Keep your equipment away from radiators and heat sources. Keep your equipment away from extremely hot or cold temperatures to ensure
that it is used within the specified operating range.
l
Do not stack equipment or place equipment so close together that it is subject to re-circulated or preheated air
When operating your equipment:
CAUTION: Do not operate your equipment with the cover removed.
Appendix: Safety Instructions | 76