IWT Eventa L Tandem, User Handbook Manual

Page: 51 / 71

5.3.2 Operation
5.3.2.1 Opening the partition
1. Remove the linch pin from the retainer hook
2. Lift up the retainer arm to unhook it from the retainer side rail.
3. Lower the retainer arm.
4. Swing open the partition to against the RHS wall.
5. Straighten out the head leaf so it is out of the way.
6. Tie the partition to the RHS wall by hooking the rubber bungee on the top rail to the
partition.
5.3.2.2 Closing the partition
1. Untie the partition from the side wall and put the bungee into its storage position.
2. Fold the head leaf 45 degrees relative to the partition to allow the retainer arm to raise up
past horizontal.
3. Raise the retainer arm.
4. Swing the partition and head leaf into the required position.
5. Lower the retainer arm and hook it into the retainer rail
6. Insert the linch pin into the hook end to secure it.
It is important that the head leaf and retainer arm are not parallel to the main partition leaf in the
closed position, there is an anti-lift device on the retainer arm to prevent you from doing this. Do
not force the partition into this position. Aim to have the head leaf and retainer arm at an angle to
the main partition leaf.