IWT Eventa L Tandem, User Handbook Manual

Page: 38 / 71

3.5 Table & Lower Bed
•
Do not at any time sit or stand on the table.
3.5.1 Lower Bed Assembly
1. Unclip the two quarter turn buckles under the table top against the wall.
2. Press in the clip half way up the table leg.
3. Lift up the table top.
4. Rotate the table top clockwise 90 degrees so the chamfered corners are to the left.
5. Lower the table top down onto the lower supports on the bench bases and front wall.
6. Pull off the upper back cushions from the walls and place on top of the table top.
•
It is now safe to sit and lie on the table top.
3.5.2 Table Re-assembly
1. Rearrange the cushions back to their seat positions.
2. Lift the table top.
3. Rotate the table anti-clockwise so the chamfered corners are towards you.
4. Lower the table and line up with the table leg first.
5. Lower the table onto the wall support
6. Buckle up the two quarter turn catches under the table against the wall to secure it.
•
It is now unsafe to sit or stand on the table top.
3.6 Bunk Bed, Ladder & Safety Net
The upper bunk bed can be simply raised and lowered by pushing it up or pulling it down. It is held in
place with gas spring struts that require no further action to lock it in place. Be prepared to hold the
weight of the bunk as it lowered so not to let it slam down.
•
Lower the bunk into the lowered position when in transit.
A ladder is provided to access the upper bunk and should be hooked into the locating brackets on
the bunk side before safe use. Store the ladder on top of the bunk when not in use and wrap the
safety net up over and then under it to stop it moving around during transit.
The Safety Net is provided to prevent you falling off during sleep. After climbing onto the bunk clip
the two straps from the top of the safety net into the receivers on the ceiling.