Iveco DAILY 4x4, Instructions Manual

Page: 99 / 110

CHASSIS MODIFICATIONS
2-75
D
AILY
4x4
Print 603.93.761 Base - May 2007
Electrical System: Modifications and Drawing-Off Power
2.16.6 Operations to adjust overhang
If the length of the wires on the chassis are modified to accommodate the new overhang, a watertight joint must be used with
the same specifications as those used on the standard vehicle. Components used - such as wires, connectors, terminals, ducts etc.
- must be the same type as those used originally and must be fitted correctly.
As far as electronic control device function is concerned, no joins are permitted: the cable must be rep laced by a new cable with
the same specifications as that used on the vehicle, and of appropriate length.
2.16.7 Provision for trailer
If the tail-lights are repeated on the trailer, fit the vehicle with a 13-pin trailer point.
It is not permitted to connect directly to the original equipment tail-light lights. Connection to the original vehicle tail-lights could
cause current overloads that will be indicated by the on-board computer as operating faults.
If it is necessary to make changes to the system other than those described in this manual (e.g. inclusion of LED lights), the operation
must be carried out in conjunction with Iveco.
a) Trailer connector added by the body builder
If the vehicle is not ordered with a trailer point, a set may be ordered from parts. This consists of:
- electronic control unit;
- control unit fastening brackets;
- front bridle for connecting the control unit with the bonnet cable and chassis cable sectioning;
- chassis cable with 13-pole connector.
Installation
To ensure correct installation, the following instructions shall be followed:
- fit the electronic control unit onto the bracket next to the radiator, as illustrated in the pictures.
Figure 2.46
114195
114196
1
2
1
FRONT VIEW
1. Electronic control unit - 2. Radiator
REAR VIEW
1. Interfacing connectors