Iveco DAILY 4x4, Instructions Manual, Page: 83 / 110

CHASSIS MODIFICATIONS
2-59
D
AILY
4x4
Print 603.93.761 Base - May 2007
Electrical System: Modifications and Drawing-Off Power
- Use existing holes for routing the cable. Take all the necessary precautions for protecting the body if additional hole have to
be drilled (use anti-rust paint, sheath, etc.).
- Ensure a good connection with the vehicle earth both at the base of the antenna and at the device fixing to ensure maximum
power transfer.
Radio transmitters are typically fitted on the dashboard in the gear lever area or in the header rail above the driver (see Figure 2.33).
Figure 2.31
1. Antenna support - 2. Gasket (P/N for spares 244614) - 3. Fixed joint cover (P/N for spares 217522) - 4. Fixing screw
M6x8.5 (torque to 2 Nm) - 5. Antenna (spare P/N for complete rod 675120) - 6. Roof - 7. Antenna extension lead
98915
Figure 2.32
1. Antenna connector - 2. Ground wire - 3. Insulator - 4. Signal wire - 5. Capacitor (100pF) - 6. Cable RG 58 (characteristic
impedance = 50
Ω
) - 7. Clamp - 8. Protective cap - 9. Connector (N.C. SO - 239) transceiver side - 10. Test executed sticker
- 11. The 100pF capacitor must be soldered on the lower pin and crimped to the ground braid - 12. The lower pin must be
soldered to the core conductor of the cable - 13. Nut
99349