5.
Hand tighten bolts.
Figure 9: Shims or wedges - side view
Figure 10: Shims or wedges - top view
3.3 Alignment and alignment procedure
WARNING:
Before beginning any alignment procedure, make sure driver power is locked out.
The points at which alignment is checked and adjusted are:
•
Initial Alignment is done prior to operation when the mixer and the driver are at ambient tempera-
ture.
Final Alignment is done after operation when the mixer and driver are at operating temperature.
Alignment is achieved by adding or removing shims from under the feet of the driver and shifting
equipment horizontally as needed.
NOTICE:
Proper alignment is the responsibility of the installer and user of the unit.
Accurate alignment of the equipment must be attained. Trouble-free operation can be accomplished by
following these procedures.
3.3 Alignment and alignment procedure
14
3501 Installation, Operation, and Maintenance Instructions
