ITS Telecom CGW-D, Installation And Operation Manual, Page: 10 / 59

CGW-D
1-3
1.5 Getting Started
Getting started with the CGW-D comprises of the following steps:
Preparation to operation:
Connect the device to 9 VDC power using the supplied adaptor.
Install the supplied GUI software on a PC (refer to Chapter 2 for instructions).
Install USB drivers (refer to Chapter 2 for instructions).
Connect the device to PC via the USB interface.
Program the device as required.
Device installation:
Connect the antenna to the antenna connector.
Insert a SIM card into the port.
Connect the device in one of the following configurations, according to its purpose:
ƒ
Private use at home (Figure 1-3).
ƒ
Office trunk use (Figure 1-4).
ƒ
Office trunk gateway (Figure 1-5).
Make sure not to connect the PSTN line to the phone (FXS) socket! This connection
may harm your FXS interface hardware.