ILS Strobe Lighting Systems
DOC-3400-MNL Rev23.doc
(9/22/2021)
Copyright 2007-2021 ITL, LLC Page 56
of
86
.SW5-1
SW5-2
SW5-3
Strobe Type
OFF
OFF
OFF
Dual Strobe
OFF
ON
OFF
Red Strobe
ON
OFF
OFF
White Strobe
ON
ON
OFF
White Strobe / Red LED Dialight Series
ON
ON
ON
White Strobe / Red LED ITL-1700 Series
SW5-5
SW5-6
Alarm Threshold
Installed Bulbs
OFF
OFF
1
2
OFF
ON
2
3
ON
OFF
2
3
ON
ON
0
0
If the ITL-3400 does not seem to respond to the configuration switches the board may
have been configured with remote software. If necessary the board can be reset to
factory defaults and will then follow the setup of the hardware configuration switches.
iii. Factory Reset Switch
SW1 can be used to clear all remote custom programming and reset the main board’s
non-volatile memory to factory defaults. This is useful if a board is moved from one
power supply to another and particularly if remote communication is not utilized. To
perform this reset, hold the switch down for 5 seconds during power up only.
Figure 53: Strobe Configuration Detail Table
Figure 54: Sidelight Configuration Detail Table
Figure 55: ITL-3400 Factory Reset Switch Location Detail
