charger controller, the used Baud rate needs to be consistent. The user needs
to manually set the communication parameters of the electronic load and
protocol.
•
For detailed setting methods, refer to the corresponding User Manual of
electronic load. Select the corresponding Baud rate of the RS-232
interface as 38,400.
•
The host computer control software communicate with through
SCPI protocol, therefore, the load present protocol must set to
SCPI.
Installing the Driver
To communicate the PC host computer with the quick charger controller, the
user can select the USB interface or the RS-232 for communication. When the
RS-232 communication is used, the driver program of ITECH vcp Driver Instal-
ler needs to be installed. Please get the driver program from the soft installation
disk.
Installing the Software
1. Get the installation software from the soft installation disk.
2. Decompress the installation file of USB Charger Software to the local folder.
3. Double click the exe installation file, and install it to the specified path in ac-
cordance with the installation instructions.
2.3.2 Software Function Introduction
In this series of quick charger controller, only IT-E255A supports the connection
of host computer software of USB Charger Software and the execution of auto-
matic test. Please refer to the model of purchased quick charger controller.
2.3.2.1 Interface Introduction
1. Double click the USB Charger Software to run the program. The interface
displays is shown below:
Copyright © Itech Electronic Co., Ltd.
19
