SECTION 11
ENTERTAINMENT
11-4
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna
- Turn elevating crank
clockwise in “UP” direction or until some resis-
tance to turning is noted. Antenna is now in oper-
ating position. Turn amplifier power switch
“ON” to receive TV signal.
Rotating Antenna
- Make sure antenna is in
the “UP” position. Pull down on rotating knob
until it disengages ceiling plate and rotate for best
picture and sound on TV set.
Lowering Antenna to Travel Position
- Ro-
tate antenna until pointer on rotating knob aligns
with pointer on ceiling plate.
Turn elevating crank (counterclockwise) in
“DOWN” direction until resistance is noted. An-
tenna is now locked in travel position. Turn am-
plifier power switch “OFF”.
Check Antenna Light
The check antenna light will come on for 20
seconds when the ignition switch is turned on to
remind you to be sure the TV antenna and/or sat-
ellite dish are lowered completely into the roof
cradle for travel storage.
TV Antenna Signal Amplifier
The amplifier power switch is located on the
video selection system panel in the video center
cabinet above the driver and passenger seats or
entertainment center cabinet.
Never allow the antenna to touch
electrical power lines or any other
electrical wires.
WARNING
Always align directional handle to
“DOWN” position before lowering.
CAUTION
“Check Antenna”
Light
