WatchPAT™300 System
22
Operation Manual
Remove a used probe by pressing the small tab (clip) marked by the arrow in Figure 6, and
then, holding the connector’s slider, gently slide it away from the probe – do not pull the
slider off by pulling the cord, as it may damage the wiring. Properly dispose of used probes.
Figure 6
– Disconnecting the
Probe
Figure 7
– Probe Disconnected
Connect a new probe by inserting the blue slider to the probe until the blue tab of the probe
clicks into its place.
Note
Take care when inserting the blue slider to insure proper seating in the
probe.
