10
Pay attention to the exact
horizontal and vertical
location of the roller shut-
ter
Cut the sealing insert
see the diagram on the
other side
1. Check the dimensions of the roller shutter and the construction hole or the window
2. On the box cut the outlet for the strip, cable or lever of the conical gearbox and drill the passage on the wall or in the window. To prevent
damage to the strip, it is necessary to drill the passage for the strip perpendicularly, if possible. Pay attention when drilling to the handle
bar; the square must be located centrally in the drilled hole and must not be in contact with the walls in the hole and the scrub in them.
(For the 14 mm strip, drill about 16 mm / for strip 23 mm strip, drill a hole of about 32 mm / for the cable, drill a hole about 10 mm / for the
conical gearbox, follow the manual).
3. Insert the guiding bars into the leg of the side wall; check the
guiding bars are the same height. (The insertion of the guiding
bar into the side wall must not damage the starting point of the
armour located in the side wall.)
4. Marking of drilling points in which the screws fix the blind (the
size is according to the masonry and screws used).
Stage drilling when
using PVC
cover caps
installation to window
frame
Drilling through the
guiding bar (without
cover caps)
installation to reveal
CONTROL USING THE STRIP OR THE CORD
5. On the strip attach the penetration, plastic tube, tape roll, etc.
(roll downward, brush upward).
6. Suspend the strip or the cord into the spring clamp so that dur-
ing the movement of the armour the upward strip is automati-
cally wound into the winding mechanism (according to the
construction the winding mechanism must be open and the
strip must be hooked and fixed to the spring mechanism).
We advise that when shortening the strip, the blind armour
must be lowered. When working with the strip, the spring
mechanism must be secured against winding!
7. Fixation of the winding mechanism on the frame of the win-
dow or the wall.
8. Fixation of the strip penetration on the wall or the window
frame (the roll simplifies the movement of the strip).
INSPECTION
Before assembly we recommend inspecting all the parts after delivery of the goods to prevent any problems. The manufacturer must be
notified of any defects or comments concerning the assembly or roller shutter.
