Isotra ARTOSI, Measurement And Assembly Manual

Page: 4 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
4
(40 × 1.8 mm) for water draining (not part of delivery) into the pole and apply sealing compound to
the funnel, see Fig. D.1.
A.3 Adjust the height of the pole A1 according to the actual passage height (the pole height can be
adjusted in the range of + 2 cm) and tighten the four countersunk bolts M8. When fitting the pole to
the foot, the pole is at the
– 2 cm position of the set height.
A.4 Repeat steps A.2 and A.3 for the remaining poles.
A.5 Insert the perimeter section A1A3 in the pre-installed pole A1 and pole A3. Do not hold the perimeter
section by the eaves part only
– hold it by the main supporting section. Otherwise eaves will likely be
damaged.
If the pergola is placed under a roof or truss, it is necessary to allow for at least 380 mm above the
pole inserted in the foot for inserting the perimeter section.
A.6 Secure the connection of the perimeter section A1A3 and pole A1 by pre-installed bolts (4 countersunk
bolts M8 for each pole).
A.7 Secure the connection of the perimeter section A1A3 and pole A3 by pre-installed bolts (4 countersunk
bolts M8 for each pole).
A.8 Repeat steps A.5 through A.7 for the perimeter section C1C3 and pole C1 and pole C3.
A.9 Prior to installing the perimeter section A1C1, insert reinforcement to both sides of the section. Then
connect the section A1A3 and perimeter section C1C3.
Prior to installing, apply sealing compound to
the side cover of the drainage channel, see Fig. D.2. Insert the perimeter section A1C1 between the
pole A1 and pole C1 so that the pre-installed 6HR screws fit in the grooves. Tighten the pre-installed
6HR screws on both sides of the perimeter section A1C1.
A.10 Insert two cup- head bolts M10×20 to each corner of the frame and tighten.
A.11 Insert one hexagon- head bolt M10×340 to each corner and tighten. If the pergola is placed under a
roof or truss and the room above the pergola is not sufficient for inserting the bolts, do not use the
bolts. This does not affect the pergola function.
A.12 Repeat steps A.9 and A.10 for the perimeter section A3C3.
A.13 Check the dimensions of the diagonals, check the frame flatness and pole verticality, and adjust if
necessary.
A.14 If no problem is found, tighten the fastening nuts in the perimeter section, tighten the nuts in feet and
overlap the gap by the pole cover section. Attach the cover section to the pole (use bolts or silicone).
A.15 Insert the individual slats in the corresponding side sockets and secure with locks. The side sockets in
the perimeter section
are adjusted to 45° slat tilting. The first slat and the last slat must be oriented
with respect to the limit sections attached to the perimeter sections A1C1 and A3C3.
A.16 Connect the motor and lighting, if any, and hide the cables inside the perimeter section and transverse
section.
A.17 If the pergola includes a LED lighting unit, connect it using connecting plugs.
A.18 Connect the LED lighting unit to the power supply unit using a cable with Hirschmann terminal.
A.19 Test the slat tilting function; the end-of-travel positions are factory-set. It is not possible to adjust the
limit section for opening, as this will likely lead to the slat mechanism collision.
A.20 Attach the side covers to the perimeter sections.