Isotra ARTOSI, Measurement And Assembly Manual

Page: 16 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
16
The LED supply unit is placed within the transverse section (A1-C1 or A3-C3). The unit is powered from the
central box using a Hirschmann terminal.
The LED supply unit contains a 220/24 V transformer, LED io receiver, connecting box. The unit can be
removed from the transverse section.
It is possible to equip the pergolas with LED strip lighting – 24 V DC, warm white colour, CRI 90+. The LED
strips are integrated from below in the drainage channel, the strips are located on both longitudinal sides of
the pergola (A1-A3 and C1-C3).
The LED strips are powered using cables with screw connectors for fast connection.
THE ACTUAL EXECUTION OF THE INDIVIDUAL POWER SUPPLY UNITS MAY DIFFER ACCORDING TO THE
METHOD OF CONTROL, NUMBER OF MOTORS, AND INSTALLED TYPE OF LIGHTING!
Multi-motor Pergolas
Controls are carried out by Situo 5 Variation io controller (or other types of controllers).
If the pergola is supplied with a controller, the individual motors are paired up with the controller incl.
lighting, and they are set to the end positions of the motors (start and end position of the slats).
If the controller is not supplied, only the end positions of the motors are set. In such cases, the motors must
be paired up with the controller before the assembly. In doing so, it is necessary to remove the central power
supply box from the upper section, see fig. below, open the box and use the Wago clamps to leave only one
motor energised and pair the motor (only one motor may be energised in order to pair it with the controller).
DO NOT ALTER THE ADJUSTMENT OF END POSITIONS, AS THIS WILL LIKELY CAUSE THEIR COLLISION AND
DAMAGE!!!