Isotra ARTOSI, Measurement And Assembly Manual

Page: 17 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
17
INSTALLATION OF SHADING TECHNOLOGY
We recommend installing the shading technology between the pergola poles, (installation to opening), using
the revealed installation method. Installation between the pergola pole and the building wall is more
complicated, as regards both measurement and assembly
– attachment of guide rails to the wall. We do not
recommend anchoring the guide rails through the building’s external insulation. In such cases, it is advis able
to install the pergola pole near the wall and anchor the guide rails of the screen roller blind in this pole.
When installing our screen ZIP roller blinds, we recommend to always use guide rails type 838.
With respect to the dimensions of poles used for the Artosi pergolas (110 × 110 mm), we recommend using
110 mm box when installing screen roller blinds. If a larger box is used and the roller blinds are attached to
the pergola corner joints, the rear sides of the boxes will collide, and in such a case neither roller blind can be
installed so that it fits against the outer edge of the perimeter sections!
If the pergola is installed onto the building and the screen roller blinds are ordered together with the
pergola, we recommend measuring the inclination from the building during the initial measurement. The
measured values should then be considered in the order form to specify the accurate height of the screen
roller blind (difference in the length of the guide rails).
If shading technology (screen roller blinds) is to be installed later – after the supply of the pergola – it is
necessary to carefully consider the installation of wiring. It is necessary to carefully choose the position of
drilled holes in order not to damage the water draining chambers. If the situation so requires, cables may
also be installed on the upper surface of the perimeter section.