Isotra ARTOSI, Measurement And Assembly Manual

Page: 11 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
11
Wall Mounting – Variant C
Prior to taking any measurements, check the surface to which the pergola is to be installed. Measure the
surface inclination, difference of level at the house wall and on the opposite side of the pergola. Place the
pergola in accordance with the client’s instructions (to the centre, to the left side, etc.). Check the wall
flatness at the perimeter section installation area.
C.1 Indicate on the wall the position for the installation of the perimeter section A1A3, based on the
measure-taking. Take the measures by starting on one side and then indicating the placement of the
individual feet diagonally. In doing so, pay special attention to alignment and connection of the
pergola poles to the water outflow. When taking measurements of the openings for the attachment of
locations A1 and C1 (their height from the surface), take the surface inclination into account. This way
you will ensure the same passage height on both sides of the pergola and the flatness of the perimeter
section.
C.2 Remove the eaves gutter from the perimeter section A1A3 (the gutter is not treated with sealing
compound at the lower side).
C.3 Drill the wall mounting holes to the space below the eaves (the quantity and spacing of the holes
should respect the material to which the pergola is to be anchored). The sections have already been
predrilled
– 3 holes of 28 mm diameter.
Drill more holes if necessary.
C.4 Use a suitable anchoring system to attach the perimeter section A1A3 (e.g., M10 threaded rod,
chemical anchor). Apply polymer- or polyurethane-based caulk (1) to the upper edge of the perimeter
section, see Fig. C.6.
C.5 Attach the eaves gutter to the perimeter section A1A3. Do not forget to apply sealing compound to
the lower side!
Then proceed in accordance with items A.1 through A.14.
C.6 Attach the cover section (4) to the pergola perimeter section and to the wall. Apply compression tape
(2) to the cover section and attach the section to the perimeter section using Tex bolts with packing
rubber (3). Apply polymer
– or polyurethane-based caulk (1) to the upper edge of the cover section (1).
Then proceed in accordance with items A.15 through A.20.