Isotra ARTOSI, Measurement And Assembly Manual

Page: 18 / 21

MEASUREMENT AND ASSEMBLY MANUAL
Validity of the manual: 21.3.2022
18
UNPACKING AND STORING THE PERGOLA
In most cases, the pergola is supplied in wooden crates. We therefore recommend unloading the crates from
the vehicle using a fork-lift truck. If a fork-lift truck cannot be provided, open the crates on the vehicle and
carefully unload the individual parts of the pergola and place them on a flat surface
– crate cover, etc. Check
the crates and components inside them for any damage caused by the transport.
Store the pergola in the original packaging. If not installed immediately after unloading, store the pergola in a
dry place and protect it from direct sunlight.
Be careful when unpacking the pergola, check whether all parts are intact, do not damage the paintwork. In
case of any defect, document the defect and continue the assembly according to the manual. Only skip
processes where sealing compound is to be applied! (This is due to possible replacement of defective parts,
does not apply to slats).
1. CONTROL
Motor with integrated IO receiver
The control is performed with the Situo 5 variation io controller (or possibly another IO controller).
If the pergola is delivered with an IO controller, the individual motors are paired with the controller and the
extreme positions of the motors are set (start and end position of the slats). If the IO remote control is not
included in the delivery, only the extreme positions of the motors are set. In this case, the motors must be
paired with the controller before the initial start-up, or other settings must be made according to the
instructions of the drive used. Do not change the setting of the extreme positions of the slats, they may
collide and be damaged!!! If the pergola is equipped with integrated LED lighting, this lighting is paired with
the remote control. Any reprogramming can be performed according to the instructions for Somfy LED
lighting receiver IO.
Motor without integrated WT receiver.
The control is performed by a local wall button connected by a wire path to the pergola drive. If these motors
are connected to the control of a smart home, the control usually takes place via specific controls of the
given manufacturer (actuators, applications, remote controls). If you use a control system, first familiarize
yourself with the instructions provided. Do not change the setting of the extreme positions of the slats, they
may collide and be damaged!!!
Always operate the pergola from a place that allows a complete overview of the movement of the pergola
roof.