IPBridge Installation Guide
Page 13
Figure 03
4: IP-BRIDGE POWER
The IP-Bridge can be powered with PoE, PoE-Plus, or DC power in the range
of 12VDC to 28VDC.
NOTE: DO NOT power the IP-Bridge with PoE and 24VDC. If you are powering
with external power, please ensure your network cable is providing data only.
Using PoE and 24VDc will void the warranty.
4.1
: PoE POWER
PoE power can used to power the IP-Bridge itself and is commonly used
to provide power to the components at the door, such as an electric lock,
a Wiegand device, and/or a passive infrared motion detector.
The IP-Bridge can be use two types of PoE.
PoE ( IEEE 802.3af ) --- 13 watts of power can be supplied to the
IP-Bridge, via a PoE network switch that meets the 802.3af
standard. 13 watts is enough power for the IP-Bridge itself and a
single door’s typical hardware (dumb-reader and lock).
PoE-Plus ( IEEE 802.3at ) --- 25.5 watts of power can be supplied
to the IP-Bridge, via a PoE network switch that meets the 802.3at
standard.
The IP-Bridge will auto-adjust to accept the type of PoE being supplied by the
network switch.
