Page
4
General Product Information
The RLA Style 3 is intended as a control device to guard a residence from flooding due to domestic water leaks that may
occur when the residence is unoccupied. A latching solenoid valve will close, thus turning the water supply OFF.
Available options for the RLA Style 3 allow the controller to guard a part time or vacation residence from flooding due to
domestic water leakage that may occur due to freezing temperatures and also against seismic activity that may break piping
for gas and water service.
Construction
All electrical components are pre-assembled, wired, and mounted. The Electronic Controller is assembled within the
Utility Controller compartment.
The RLA Style 3 Controller has a powder coat finish. All panels and enclosures are constructed of welded 14-gauge sheet
metal.
Caution:
Do not drop this assembly or expose it to the environment.
Assembly, Compliance and Registration Information
All Controllers are assembled to permit limited field configurations of the operating system. Options requiring additional
instructions and/or assembly parts are shipped within the component package. Refer to Equipment Specifications to verify
that ALL components conform to these requirements.
The output circuits of the Controller provide control signals to solenoids and relays to activate and engage the various
utilities.
ISIMET
provides a full line of Companion Enclosures and fittings. It is recommended that these items be included
in the system design, but when the installer elects to provide these fittings from other sources, compliance with product
specifications must be confirmed prior to installation.
Enclosed with this Manual is a separate registration form. The front of the form is for equipment warranty registration.
The back is a copy of the equipment start-up checklist. To ensure proper warranty of the product, it is important that you
complete both sides of the form and either mail or fax to
ISIMET
within 30 days of installation and start-up.
Locating and Positioning the Controller
Where applicable, verify ADA (Americans with Disabilities Act) dimensions and compliance requirements. For best
results: Install the Controller in the room where the utility services are controlled, at or near an exit, and accessible to
occupants of the room. Mount the vertical center of the service switches on the door panel to the ADA-required maximum
height.
The Door Panel and Trim Kit
The Trim Kits are packaged separately from the RLA Controller enclosure and have a protective wrapping. (Trim Kit not
provided with surface mounted units.) Verify installation requirements prior to installation of the unit.
Store the Door Panel and Trim Kit in a protected location, out of the weather, until installation.
Install the Door Panel onto the RLA Controller after ALL other wiring connections within the controller have been made.
Upon Receipt of Product
Each RLA Controller is assembled specifically for an individual application.
All primary components have the same code number.
Check components for damage. Notify
ISIMET
immediately of any damaged components.
Check package and product name plates to determine if all components were shipped correctly.
Store uninstalled components in a protected environment, out of the weather.
Note:
Only qualified craftsmen licensed within the governing jurisdiction to perform the work associated with this
installation should install and/or service this equipment.
Summary of Contents for RLA Series
Page 5: ...Page 5...
