ISHIDA Omni-4000ST, User Manual

Page: 3 / 135

Important Notice
Thank you for purchasing the ISHIDA Omni-4000ST.
This manual explains the procedures to install, operate, and maintain the machine.
Those who handle the machine must be aware of the hazards involved. These dangers may not be
obvious, so it is imperative to follow the instructions detailed in this manual when installing, operating,
and maintaining the machine. Therefore, we recommend that you thoroughly read and understand this
manual before installing, operating, or maintaining the machine, and keep this manual in a safe place
where you can refer to it whenever necessary.
Safety countermeasures should be carefully considered and implemented before performing any
installation, operation, or maintenance procedure not specifically described in this manual or indicated
on the machine itself.
ISHIDA is not liable for any damage, loss or injury that results from incorrect operation, insufficient
caution, unauthorized modifications to the machine, or failure to follow the instructions contained in this
manual.
Change in Specifications
Machine specifications and accessories may be changed at any time due to improvements or other
reasons. Consult with your ISHIDA representative at any time to confirm the actual specifications of the
purchased machine.
Errors and Omissions
The information in this manual has been carefully checked and is believed to be accurate. However,
please understand that the descriptions in this manual may not agree with the actual machine due to
machine improvements. The information is subject to change without prior notice in the future. ISHIDA
assumes no responsibility for clerical, typographical or proofreading errors, or omissions.
Limitations of Liability
ISHIDA assumes no responsibility for special, indirect, or consequential damages, loss of profits or
commercial loss in any way connected with the machine, whether such claim is based on contract,
warranty, negligence, or strict liability.
SHIDA shall assume responsibility for problems with the machine or the system based on an individual
maintenance contract. However, ISHIDA shall not be responsible for secondary problems.
ISHIDA assumes no responsibility for the user's programming of this machine, or any consequence
thereof.
In no event shall ISHIDA be responsible for warranty, repair, or other claims regarding the machine
unless ISHIDA’s analysis confirms that the machines were properly handled, stored, installed, and
maintained and not subject to contamination, abuse, misuse, or inappropriate modification or repair.
Omni-4000ST User’s Manual page i