12
isel
-CNC Compact Equipment CPM
5
Commissioning
5.1
Preparations
For controlling the CNC machine and/or the FLASH EPROMs, you require one
IBM compatible computer with a free serial interface.
The system requirements of the control PC depends on the
respective operating system and the interpreter software (control software)
Connecting cables
The serial port is used as an interface of the machine to the computer using the enclosed
cable (max. three meters in length, you find the pin assignment of the 9-pin Sub D connector
in the Specification section).
Connect the red
connector of this cable to
the PC. This side of the
cable is again marked
with <<PC/AT<<.
Connect the gray coupler
on the reverse side of the
CPM.
Use the multiple socket
strip for connecting
power to the computer
and to the machine.
Connect the power cable
only if the machine is
ready for commissioning.
Mount the
axis of rotation
(optional) onto the T-slot plate in accordance with the assembly
and operating instructions of the axis of rotation in the appendix. Connect the cable to the
axis of rotation and the female Sub D-9 connector in the rear wall of the working space.
How to precisely set up the axis of rotation is also described in the assembly and operating
instructions in the appendix.
