Page 11 of 18
Ensure the blade comes to a complete stop before removing material.
Only operate with the guards in place.
Do not use toothed blades.
Never attempt to free a stalled wheel without first turning the saw OFF and disconnecting the saw
from the power source.
Never stand or have any part of your body in line with the path of the wheel.
Avoid awkward operations and hand positions where a sudden slip could cause your hand to
move into the cutting tool.
Never remove the riving knife. The distance between the cutting blade and the riving knife should
not exceed 1/5in.
Do not use a cutting blade that is bent, deformed, or otherwise damaged.
Never begin cutting tiles before the machine reaches its full speed.
Do not leave the work area until the tile saw has been switched off and the cutting disc has come
to a complete standstill.
Never attempt to stop the cutting blade by exerting pressure on the side of the blade.
Always unplug the tile saw before performing any maintenance.
Do not use the tile saw before it has been completely assembled and installed according to the
instructions.
Do not perform any design, assembly, or construction activities on the table.
Always run with cold water.
Straight Cut / Bevel Cut
1. Set up the tile saw on a level, non-slip ground; it should not wobble.
2. Be sure the water level in the trough is high enough to contact the wheel and keep it wet during
the entire operation.
3. Direction of feed: always feed work into the saw against the direction of rotation.
