Page 9 of 18
Main Parts of Tile Saw
Subassembly
Table
Power Switch
Switch Plate
Fixed Clamp
Tray
Fence
Upper Blade Guard
Assembly Instructions
1. Insert the adjusting bracket (1) but do not tighten the screws (M4x10).
2. Fit the diamond cutting wheel. Insert the inner flange (3) in the drive shaft. Mount the cutting wheel
(4) on the inner flange (3) (note the direction of rotation). Insert the outer flange (5) and then tighten
with the nut (6).
3. Align the adjusting bracket (1) in one direction with the cutting wheel and tighten the screws (2).
4. Put on the guard hood (7) and attach with the locking knob (8) and the nut (9).
5. Fasten the locking knob (8).
6. Insert the straight fence (10) parallel with the guard hood on the table (desired position).
7. Screw in the clamping screw (11) and fasten the table in the inclined position required.
