12
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 10
Figure 9
To install the “Outside Air Kit,” position the clip so that the nut is directly
above the hole punched in the back of the heatshield (See Figure 11).
Install the outside air adapter box on the stove by sliding it into the air
channel located between the bottom heatshield and the stove bottom until
the oblong ring is approximately 1/4” from the rear edge of the lower
heatshield. Make sure the ring is facing down. Thread the 1/4” bolt up
through the nut in the clip until snug against the adapter box.
To locate the hole in the hearth for outside air, mark a 4” circle on the
hearth. The circle’s center should be 2-3/4” directly back from the center
of the flue outlet and 5/8” to the left side.
Expanded View of Clip
NOTE: The threaded rods used to bolt the legs to the stove are pack-
aged with the heatshield, as a heatshield is required when a stove is
installed on legs.
Residential and Mobile Homes
(Bolting down and grounding of stove are required only in mobile
homes).
Open all cartons, if any and remove the contents upon receipt and check
for any damaged or missing parts. If there is hidden damage, notify your
freight company or IHP dealer immediately.
CAUTION: Wear gloves during installation in case of sharp
edges on the stove.
Leg Installation
1. Carefully place stove on its back. Be careful not to scratch the
stove, use a piece of cardboard or carpet to protect the back of
the stove.
2. Mount all four legs as shown in Figure 9.
3. First, screw the threaded rods into the holes at the four corners
on the bottom of the stove. Screw the threaded rods into the
firebox three full rotations or 3/16 to 1/4” (if the rear rods are
screwed in too far they will lift the bricks off the bottom of the
stove). Use a washer and nut to secure the leg. Be sure the
legs are mounted squarely on the firebox bottom. Tighten nuts
securely.
4. Use the two bolts and washers provided with the heatshield kit
to mount the heatshield as shown in Figure 10.
5. Do not over tighten the heatshield mounting bolts as it may bend
the heatshield.
Line up the hole in the clip with the hole in the
rear center of the bottom heatshield
Clip
1/4” Bolt
LEG AND HEATSHIELD INSTALLATION
OUTSIDE AIR KIT INSTALLATION
Figure 11
Threaded Rod
Washer
Nut
Air Channel
Heat Shield
Mounting Holes
FRONT
BACK
