4
Step 5:
Insert the BASE FOOT into the POST FRAME and hold in place with 2x M8 screws and
2x washers. Do not tighten to allow for fine tuning later. The POST FRAME holes are slotted to
allow for fine tuning foot position once Assembly is complete. Once the attachment is secured to
the Super Bench/Super Bench PRO, tighten these M8 screw assembly When BASE FOOT is
resting on the floor.
6
SUPER BENCH PRO:
The Hypercore
attachment can be used with the Super
bench PRO. The only requirement is that
the seat pad must incline by one notch due
to the Super bench PRO’s reduced height.
The FOOT HOLDER
FRAME can be adjusted
up and down for users of
different heights using the
Pull Pin. You should be
able to comfortably bend
at the waist.
Step 4:
Slide completed FOOT HOLDER FRAME onto
the POST FRAME . You must turn and pull the Pull-
Pin up prior to sliding the FOOT HOLDER FRAME onto
the POST FRAME. Once Pull-Pin aligns with POST
FRAME hole, release Pull-pin and a noticeable “Pop”
will occur when the Pull-Pin engages a hole.
To Slide/Adjust
FOOT HOLDER
FRAME. First
unscrew the Pull-
Pin until it can be
lifted. Then slide/
adjust FOOT
HOLDER FRAME
as needed and
tighten into place.
T-Pin
Note oblong holes at base of POST FRAME allow for fine tuning.
Please see notes on following page if using in conjunction with
Super Bench PRO
