4-24 IRIS OWNER’S GUIDE
SERIES 3000 Version 1.0
Workstation Administration
Using cpio
:
cpio -oh1 .
# rewind cartridge tape device
cpio -oh3 .
# rewind half-inch tape device
9. If you have any additional file systems, mount them and back them
up following the same procedure.
Backing Up a System without a Local Tape Drive
An IRIS workstation with no tape drive is backed up across an XNS Ethernet
onto a tape loaded on another workstation. Both systems must have network
communication capabilities. The system with a tape drive must have a host
name, which is referred to in this description as
hostA
, and must be in multi-
user mode.
To back up a disk onto a tape installed in a remote workstation, follow the
procedure for backing up a system with a local tape drive, but use the
command lines below for steps 4 and 8. Replace
rmt1
with
rmt2
,
rmt3
, or
rmt4
depending on your backup device (see Table 4-1).
4. Back up the root file system:
Using tar:
tar caBf - . | xx
hostA
dd ibs=10k obs=200k of=/dev/rmt1
Using cpio:
cpio -oha . | xx
hostA
dd ibs=10k obs=250k of=/dev/rmt1
8. Back up the
usr
file system:
Using tar:
tar caBf - . | xx
hostA
dd ibs=10k obs=200k of=/dev/rmt1
Using cpio:
cpio -oha . | xx
hostA
dd ibs=10k obs=250k of=/dev/rmt1
Summary of Contents for 3010
