IRIS 3010, User Manual, Page: 83 / 145

1. Boot the terminal from the hard disk, as described in Section 3.2.
2. When the
wsiris terminal emulator is running, enter the sequence ~!
to enter the C shell:
Connect to what host? ~!
The terminal displays the C shell prompt:
%
3. To run the demonstration program, enter the pathname:
~demos/flight
The first screen of the flight program appears.
4. To leave the flight program, press the
ESC
key.
The IRIS again displays the C shell prompt.
5. To return to the terminal emulator program, enter the exit
command:
exit
5.2.4 Shutting Down the IRIS Terminal
To shut down an IRIS 3010 running wsiris :
1. Issue the
~ DEL
command.
2. Set the
Power
switch on the front of the cabinet to the
Off
position.
5.2.5 Boot Failure Recovery
If a critical file on the IRIS 3010 disk becomes corrupted, the boot procedure
fails and the terminal emulator does not run. If this happens, use the procedure
in this section to restore the file system from the copy stored on the backup
partition of the disk.
1. Turn control of the IRIS over to the PROM monitor by setting
configuration switches 1 through 5 to “OCOCC” and resetting the
terminal (see Section 3.4).
Version 1.1 SERIES 3000
IRIS OWNER’S GUIDE 5-7 IRIS 3010 System Administration