Appendix B: System Messages
When the
U
nix
kernel on an IRIS workstation reaches an unrecoverable error
condition, it displays an error message preceded by the word
panic:
.
If the error message includes one of the abbreviations listed in Table B-1, the
condition is probably caused by a hardware problem. Table B-1 lists the
devices associated with each abbreviation. The abbreviated device names are
usually followed by a digit indicating a physical unit or letters referencing the
function that lead to the problem.
Abbreviation
Device
si
mt
qic
md
mf
dsd
nx
IRIS 3030 disk drive
tape drive (any type)
quarter-inch cartridge tape
IRIS 3010/3020 hard disk drive
floppy disk drive
tape, small disk, and floppy disk controller
Ethernet
Table B-1: Device Abbreviations
If the panic message does not indicate one of the devices listed in Table B-1,
there may be a hardware problem with another part of the system (processor
board, memory board, or backplane, for example) or a software problem in the
kernel.
Anytime you get a panic message, try to run
sync
and reboot (see Section 3.1 or
3.2). Run
fsck
to check the file system. If the message reappears, call the
Geometry Hotline (see Chapter 1).
NOTE:
Do not interrupt (e.g., by pressing
Ctrl-c
)
processes that are accessing the no-rewind tape device.
Attempts to do this always result in a kernel panic.
Version 1.0 SERIES 3000
Summary of Contents for 3010
