9
- NETWORK MODE
Select one between [bridge mode] and [NAT mode]. Refer to 4.1. Network
- LAN (PORT1)
These fields are for the network setting of your device. The IP address for your device
will be allocated automatically in [DHCP] selection and the IP address for your device will
be allocated as you inputted in [static] selection.
- PHONE (PORT2)
These fields are for composing sub-network in [NAT mode]. In [BRIDGE mode], this
information is not needed so you don’t have to revise it.
MAC ADDRESS cannot be revised and IP ADDRESS becomes PHONE port’s IP address
which means gateway of internal network. Input right IP, SUBNET MASK information.
- VLAN
Select enable when IP phone uses VLAN(Virtual Local Area Network).
- VLAN ID1(PHONE)
Input the same VLAN ID after checking IP phone's VLAN ID to record.
- VLAN ID2
In case of using additional VLAN ID, input VLAN ID2.
ex) In case of PC using additional VLAN connected to IP phone
- PHONE MAC ADDRESS
It is MAC address of your VoIP phone. In the case of that MAC information is not
acquired, MAC information is shown as 00:00:00:00:00:00:.
- SIP SOURCE PORT, SIP DESTINATION PORT
Usually, UDP 5060 port is used as default for SIP. However, in the case when the
different port is used, the value of this field should be modifyed. 5060 is default value.
- PICK UP CODE
PICK UP CODE is a key value used for picking up other call between VoIP phone and
