IQ Power Tools IQ 360, Owner'S Manual & Operating Instructions

Page: 10 / 19

SETUP, ADJUSTMENT & OPERATION
Chop Saw:
Features
A. Lock
Pin
B. Blade
C. Guard
D. Wheel lock lever
E. Depth Stop bolt
F. Trigger
Switch
To Carry:
Fold down unit to position where you can carry the saw. Push in lock pin (A) to lock arm down.
Unlocking:
To unlock tool and raise head, depress motor arm slightly and pull lock pin (A) out. Motor arm will then pivot upward.
Trigger Switch:
To start the tool, depress the trigger switch (N). To turn the tool off, release the trigger switch. Keep hands and material from
wheel until it has coasted to a stop. To prevent unauthorized use of tool, install a standard padlock (not included) into the
padlock hole located in the trigger.
Fence Operation:
The Fence can be set two ways:
In the stow position at back of table In guide position at front of table.
REMOVAL AND INSTALLATION OF BLADE:
1. Push in blade lock lever (L) and rotate wheel (J) by hand until blade lock lever engages slot in inside flange (S) to lock
blade. Loose the bolt or if equipped with a hand loosen quick change knob (T) counterclockwise in the center of the
blade with the 8mm hex wrench (G). Bolt has right-handed thread or (x) quick change knob.
2. Remove the bolt (T), washer (U), outside flange (V) or (x) quick change knob.
3. Make sure flange surfaces are clean and flat. Install new blade by reversing the above steps.
4. Do not overtighten bolt.
10