8
2. Conttoller(master control operation ) numbering function
The main control and sub-control (T-780K) are connected through the network cable (using the international
standard TCP/IP network protocol, and the network cable is 568B through).
2.1. The master control presses the “
SPEED-/speed-”
button to power on, and the
“MODE”
button adjusts the
arrow to
“Set Slave ID”
as shown in the figure:
2.2.
Press the
“
SET
”
button again, the main control display enters the numbering page, the
“
SPEED+
”
button and the
“
SPEED-
”
button adjust the number of the starting sub-control, as shown below:
2.3.
After completing the number setting, press the
“
SET/Save
”
button to start the numbering.
2.4.
The first step of the controller number is to automatically count the number of sub-controls. The display
"Write OK: 003"
(take 3 sub-control numbers as an example)
2.5
. The number is completed, the main control display: As shown in the figure
"Write Num: 003"
, 3 controllers
are programmed.
“
Last ID: 003
” means the last controller number is 3
Sub-control T-780K display as below:
