iPixel LED Light T-780K, Operation Manual

Page: 13 / 22

13
address.
2.5. Select down each project, press “ SET ” start to write the address; then the screen display as
“
Writing Addr...
”
，
the port indicator flashing.
2.6. After complete the address writing, the controller automatically switch to the address testing
function, then the screen display
①. AC: **** Automatic test
②. MC: **** Manual test
③. ALL All ports
OUT1-8
④.
CH MODE
：
Channel
（
Interval channel is not adjustable
）
Note: The address port is set by the
“
PORT NUM port number
”
when writing the address.
2.7. Press “ MODE ” enter “ AC ” automatic testing mode, the luminaires begin to run in succession;
the controller displays the following picture:
2.8.
Press the “MODE” button again to enter the “MC” manual test mode. “SPEED+” and “SPEED-” can adjust
the pixel points (long press “speed+” or “speed-” can be quickly incremented or decremented), and the
lamps will light up one by one; The controller displays the following picture:
2.9. After the test is completed, press
“
SET
”
to exit the channel test and return to the write
address interface.
2.10. After completing the address, restart and restart, return to the normal mode.
3. Lamps address tecting mode
（
test all the ports carry lamps of the controller
）
3.1. Press “ SET ”, and at the same time power on the controller, enter the parameter setting and
键，同时
other function interface 1.
3.2. Press “ MODE ” button to move the arrow corresponding selection “ TEST DMX ADDR ”
。