IPG Interpack ET 2Plus H275, Operator'S Manual & Parts List

Page: 32 / 78

32
R00
P
REVENTIVE
M
AINTENANCE
Knife Arm Spring Replacement
If the compression spring breaks, the sequence
to change it is as follows.
1. Carefully open the snap ring with a plier
and slide it up on the cross shaft.
Remove the snap ring attached to the
knife arm assembly. (Ware safety glasses
while working with retaining rings).
Figure 10-9
2. Slide off the repulsive pivot assembly
from current position as shown in Figure
10-10.
Figure 10-10
3. Remove the spring barrel from over
lapping position as shown in Figure 10-
11. Remove any broken particle from the
spring guide. Install new compression
spring into the captive position.
Figure 10-11
Snap Rings