IPG Interpack ET 2Plus H275, Operator'S Manual & Parts List

Page: 30 / 78

30
R00
P
REVENTIVE
M
AINTENANCE
UUU
Urethane Wipe Down Roller Replacement
These red rollers are wear items and should be inspected regularly and replaced if necessary.
Front & Rear Wipe Down Roller Replacement
Removing The Urethane Roller
1. Using a snap ring pliers, remove the
snap ring from the roller shaft.
2. Remove the flat washer and spring
washer.
3. Remove the front applying roller and hub
4. With a sharp utility knife, cut away the
red urethane roller from its mounting hub
Figure 10-5
Installing The New Urethane Roller
1. Feed the new roller onto the end of the
hub edge without the raised shoulder
2. Press the new roller all the way down to
the end of the hub and against the raised
shoulder
3. Reinstall the roller & hub onto the roller
arm shaft with the raised shoulder away
from you
4. Replace the spring washer and flat
washer
5. Replace the snap ring
6. Refer to the assembly drawing found
later in this manual for proper sequence
of assembly
NOTE: If the roller is too difficult to slide onto
the hub, use soap foam to make the uerathane
tube more slippery.
Figure 10-6