Indication
full power
Mechanism for ionizing
wires cleaning
Indication of pollution
or unit error
Main switch / control button
Indication
medium power
Indication
low power
5
SPECIAL PRECAUTIONS
Before you switch the unit, always check undamaged state of the ionizing wires in the unit. If they are
broken (not intact), do not switch the unit on! Short-circuit and even fire could occur. You will find two
40-cm long ionizing wires inside the unit about 3.5 cm behind the protective grid (at the sight from the
side). The wires are located on the side where there is the mechanism for their cleaning and go down
from the top to the unit bottom.
If you find that the ionizing wire in your Ionic-CARE TRITON X6 is broken,
please contact our service centre (see section Contacts).
In case of your longer absence, please switch the unit off and unplug the cable from the electric network
(socket). Like in other electrical appliances, peak voltage in the electrical network (caused e.g. by a
lightning) can damage the unit and even cause fire.
PREPARING FOR THE UNIT START
The unit can be in operation 24 hours daily at the temperature of 10-40oC and humidity 15–60 %.
Place the unit on hard flat surface at least 0.5 m far from objects that could prevent easy air drawing and
circulation (e.g. flying curtains and drapes, doors, pets moving etc.). The placement should also ensure
that the unit will not fall. To reach the optimum efficiency of air purification, the unit should be placed
so that its exhaust was not directed against the spontaneous air circulation but on the contrary, so that
it used it. Place the unit as far as possible from windows or any other source of draught and from warm
radiators. No metal object (like a radiator) should be placed immediately in front of the purifier; the
released negative ions would otherwise be discharged straight away. Please comply with the warnings
described in section Safety Measures. Plug the unit in an earthed socked 220–240 V / 50 Hz and switch it on.
